Processing Methods And Teaching Data Of Hair Planting Machine

It is to process the product continuously, without stopping in the middle, unless the "stop" button is pressed, and the circular processing of the product can only be realized when more than 2 fixtures are placed. Fully automatic processing can improve production efficiency, when the processing of the product on the first fixture, processing the product on the second fixture, you can replace the product on the first fixture, when processing the product on the second fixture, you can replace the product on the first fixture to achieve reciprocating processing. If only one fixture is placed, only semi-automatic machining mode can be used. In the standby state, by pressing the number key "1" on the panel, enter the fully automatic working mode, when there is protection, the whole mechanical action stops, after repairing, move the machine head to a high position, use the "single step" key to find the vacant position, and then press the "start" key to process, otherwise in the original processed hole position, press the start key processing will appear heavy hole phenomenon, may damage the needle, operation must pay attention, semi-automatic processing should also pay attention.
Semi-automatic machining:
Press the "Start" button once, process once, and after processing the product, the machine head stops at the highest position and runs to the starting point. Change the product, press the "start" key again, run to the first hole position, and process again, you can also start processing from the Nth hole to the last hole, N can be set, you can enter the hole number through the keyboard, press the upper hole, the lower hole key to run to the hole, ensure that the hole must not have been processed, and then press the "start" key to process, otherwise the needle will be damaged, and when protection appears, the treatment method is the same as that of fully automatic processing.
Fully automatic test machine:
After teaching the data of the product, in the automatic test screen, press the "upper hole" or "lower hole" button to realize a single-step hole match, you can find out whether the position of the hole is wrong, if there is an error, you can exit, enter the teaching editing interface to modify. After pressing Start, the workbench will continue to move until a product program file is completed and stop working, so that the workbench can be tested properly.